What’s in the Box
Includes all standard components.
Additional accessories vary by selected version.
Please verify all items upon opening.

包含所有標準配件，額外配件會依所選版本而有所不同，開箱時請確認所有內容物是否齊全



Brewing Guide

Follow the standard workflow for assembly and brewing.
Start by selecting the spring with your preferred tension and install it into the basket. We recommend using 20–22g of coffee, evenly distributing and tamping the grounds before brewing.

Place the secondary puck screen on top of the coffee bed before extraction, making sure the larger perforation side faces upward. Once everything is in place, lock the portafilter into the machine and begin extraction.

依照標準流程進行組裝與沖煮
首先選擇適合張力的彈簧並安裝於粉碗中，建議使用 20–22g 咖啡粉並均勻分布後壓實，沖煮前將二次分水網置於粉餅上方（請確認大孔徑朝上），完成後即可鎖入手柄進行萃取



About the Aluminum Canister

The included aluminum storage container is designed to help protect accessories and provide short-term storage for coffee beans. Before use, make sure the interior is clean and completely dry.

Apply the degassing valve sticker over the center opening on the lid, and the container can then be used for storing coffee beans or organizing baskets and accessories. It also helps keep contents dust-free and neatly separated for everyday use.

隨附鋁製收納罐提供配件保護與咖啡豆短期儲存功能
使用前請確保內部乾燥清潔。將排氣貼紙貼於罐蓋中心孔位後，即可用於咖啡豆或粉碗收納，有助於基本防塵與使用分類管理

 
 

Cleaning & Care｜清潔與保養

Daily Cleaning 日常清潔
Rinse the basket with clean water immediately after each extraction to reduce coffee oil and fine-ground buildup and keep it in optimal condition.
每次萃取完成後，請立即以清水沖洗粉碗，以減少咖啡油脂與細粉殘留，維持粉碗的最佳狀態

Deep Cleaning 深層清潔
If the holes become clogged with coffee oils or fine grounds, clean the basket in an ultrasonic cleaner for about 2 minutes per cycle. If buildup persists, repeat once more — do not exceed two cleaning cycles.
若孔洞因咖啡油脂或細粉堆積而阻塞，可使用超音波清洗機清潔，每次約 2 分鐘。若仍有殘留，可再清洗一次，但總清洗次數請勿超過 2 次

Notes 注意事項
Do not use baking soda, sodium percarbonate, stain remover powder, reducing acid cleaners, abrasive cleaners, steel brushes, or rough scouring pads. These may scratch the oxide layer, dull the surface finish, or cause fading or discoloration on anodized crystal-pattern surfaces.
請勿使用小蘇打粉、過碳酸鈉、去漬粉、還原酸類清潔劑、研磨性清潔劑、鋼刷或粗糙菜瓜布進行清潔。上述清潔方式可能刮傷氧化膜、損及表面光澤，並導致陽極上色或冰晶紋理表面褪色、變色